Plasma cutting
Free Metal Wall Art vector files
Silhouettes and geometric panels for mild steel.
- 0 files
Plasma has a wide kerf and a heat-affected zone, and these files respect both. Minimum feature size is 6 mm on 3 mm mild steel, internal corners carry a 1.5 mm relief and no island is smaller than the torch can pierce safely.
Cut paths are ordered inside-out: internal detail first, outer silhouette last, so the part stays supported by the sheet until the final cut. Lead-ins are left to your CAM software because every torch and consumable set is different.
Finish with a flap disc at 60 grit, wipe with acetate-free degreaser and powder coat, or leave the mill scale and clear-coat it for the raw industrial look.
Nothing matched that combination
Try removing a filter.
Metal Wall Art — questions we get
2 answers01What kerf should I set for a fine-cut plasma torch?
Between 1.0 and 1.4 mm for a 45 A fine-cut consumable on 3 mm steel. Always cut a 50 mm test square and measure it before running a full panel.
02Will these files work on a laser or waterjet too?
Yes. Reduce the kerf compensation to your process value and remove the pierce relief circles if your process does not need them — they are on their own layer for exactly this reason.